How to Apply Undrdog Marine+ and Marine

Quick guide on how to apply Undrdog Marine + and Marine to your boat

Undrdog Marine+ s the next-generation pro coating that provides durable environmental, chemical, and mechanical resistance along with supreme slickness, gloss, paint saturation, and hydrophobicity.

What's Needed:

Fresh microfiber towels
Applicator pads
Wax and grease remover or denatured alcohol
Adequate lighting & a timer
Gloves and a face Mask

Installation steps:

Prep the surface by wiping it with denatured alcohol or a body shop wax and grease remover. Be sure to use fresh, clean towels. Once finished, you may begin coating.
Prime your applicator pad by dripping 15-20 drops of Undrdog Marine+ or Marine onto the pad. You want the pad to be damp with the product. Throughout the entire coating process, make sure to keep your applicator pad damp by continually adding Undrdog to the pad, as needed, to maintain an even coating.
To begin, apply the coating evenly to one panel. We suggest starting on the vessel's roof and working your way to the front and around the entire boat.
Apply one panel at a time in a cross-hatch motion. This means applying the applicator pad in a vertical and then horizontal motion to ensure complete and total coverage of each panel
Complete as much as possible within a 2-5 minute (or 7-10 minutes for Marine) time frame.
Once the area is coated and the product has flashed you may begin wiping. We suggest using at least three towels for this process and working one panel at a time in the order they were applied. Start with your first panel - use one towel to wipe off the coating, one towel to buff off any remaining residue, and one as a final wipe-down to ensure no residue is left behind.
Repeat step 6 until the entire vessel has been wiped and all the coating residue removed.
Check the vessel for any residue and congratulate yourself on a job well done

Applying Undrdog Marine+ to wood, leather, and plastics:

Prime your application pad. Apply several drops (15-20) of the coating to your pad. Keep the pad damp by re-applying as needed throughout the coating process.
Apply the coating evenly to all of the plastics, trimmings, leather, etc. Once the desired appearance is achieved, do not touch it for 24 hours.

For best results:

Aim to coat in a cool shaded area - but you can apply Undrdog coatings in direct sunlight. Make sure your environment's temperature is above 45° and below 110° F when applying. Keep your area contamination-free. Use in a well-ventilated area, and always wear gloves and a face mask when working with chemicals.

Drying time and immediate after-care:

Once you are done applying the coating, wait three hours for it to dry completely. Wait 24 hours before getting your vessel wet. Do not wash with detergents for one week.

Once a whole week is up, use a pH-balanced soap for stripping dirt and grime to maintain your coating. Our Soap is perfectly compatible with all coatings. The most important thing besides washing your vessel is drying! Always dry your vehicle after it gets wet.

Storage:

Always store in a cool, dry location with the lid tightly closed.