Undrdog Help Center logo
Undrdog Help Center logo

All collections

How to Apply Undrdog Marine

Quick guide on how to apply Undrdog Marine onto your boat

Undrdog Marine is designed to have a slow flashing period allowing you to apply the coating to the entire vessel before wiping away the residue. It can be applied in most weather conditions with ease. Avoid applying in freezing or on extremely hot surfaces.


What's Needed:

  • Brand new microfiber towels

  • Applicator pads

  • Wax and grease remover or denatured alcohol

  • Adequate lighting

  • Timer

  • Gloves

  • Face Mask


Installation steps:

  1. Prep the surface by wiping it with denatured alcohol or a body shop wax and grease remover. Be sure to use fresh clean towels. Once finished you may begin coating.

  2. Prime your applicator pad by dripping 15-20 drops of Undrdog Marine onto the pad. You want the pad to be damp with the product. Throughout the entire coating process, make sure to keep your applicator pad damp by continually adding Undrdog to the pad, as needed, to maintain an even coating.

  3. To begin, apply Undrdog Marine evenly to one panel. We suggest starting on the roof of the vessel and working your way to the front and around the entire vessel.

  4. Apply one panel at a time in a cross-hatch motion. This means applying the applicator pad in a vertical and then horizontal motion to ensure complete and total coverage of each panel

  5. Complete as much as you can within a 7-10 minute time frame.

  6. Once the area is coated and the product has flashed for no less than seven to ten minutes you may begin wiping. We suggest using at least three towels for this process and working one panel at a time in the order they were applied. Start with your first panel - use one towel to wipe off Undrdog Marine, one towel to buff off any remaining residue, and one as a final wipe down to ensure no residue is left behind.

  7. Repeat step 6 until the entire vessel has been wiped and all the coating residue has been removed. 

  8. Check the vessel for any residue and congratulate yourself on a job well done

 

Applying Undrdog Marine to wood, leather, and plastics:

  1. Prime your application pad. Apply several drops (15-20) of Undrdog Marine to your pad. Keep the pad damp by re-applying as needed throughout the coating process.

  2. Apply Undrdog Marine evenly to all of the plastics, trimmings leather, etc. Once the desired appearance is achieved do not touch for 24 hours.

 

For best results:

Aim to coat in a cool shaded area - but you can apply Undrdog Marine in direct sunlight. Make sure your environment's temperature is above 45° and below 110° F when applying. Keep your area contamination free. Use in a well-ventilated area, always wear gloves and a face mask when working with chemicals.


Drying time and immediate after-care:

Once you are done applying Undrdog Marine wait three hours for it to completely dry. Wait 24 hours before getting your car wet. Do not wash with detergents for 1 week. 

Once a full week is up, use a PH balanced soap for striping dirt and grime to maintain your coating. Our Soap is perfectly compatible with all coatings. The most important thing besides washing your vehicle is drying! Always dry your vehicle after it gets wet.


Storage:

Always store in a cool, dry location with the lid tightly closed.

Was this article helpful?
Yes
No